Kitronik Servo:Lite board for :MOVE mini

Web Code: KIT5623
£13.98
The Servo:Lite board for the BBC micro:bit is a simple board that allows you to easily connect and control low power servo motors (servo's must be capable of operating at 3.3V) using the BBC micro:bit. It is connected to the micro:bit using five bolts. Connect two servos in standard configuration and it can drive up to 3 servos if the addressable 'ZIP' LEDs aren’t needed. It is powered by 3 AAA batteries and also supplies power to the BBC micro:bit, the board features an On / off switch so when it's not in use the batteries won't drain. The board also features 5 x RGB individually addressable ZIP LEDs (NeoPixel compatible) and additional external ZIP LEDs can be connected to the board as required. We've produced a range of tutorials and guides that can be found in the resources section below. We have guides detailing; how to control a third servo and how to write code for the on-board ZIP LEDs. Features: Connect two servos in standard con?guration and can drive up to 3 servos if the addressable 'ZIP' LEDs aren’t needed. Powered by 3 AAA batteries that also supply power to the BBC microbit (not supplied). On / off switch. 5 x RGB addressable ZIP LEDs (NeoPixel compatible). Additional external ZIP LEDs can be connected to the board. Contents: 1 x Servo:Lite board with battery holder pre-fitted. 5 x M3x8 Counter sunk Pozi Steel screws. 1 x Perspex spacer. Dimensions: Length: 55mm. Width: 52mm. Height: 17mm. Requires: 3 x AAA Batteries. 1 x BBC microbit. Servos. Screwdriver. Note: Once the Servo:Lite board is attached to the microbit there is a maximum clearance of 6mm for the plastic sheath of the USB cable. Our noodle cables and the cable which is supplied in the official Go pack both fit.
Web Price £13.98
Web Code KIT5623
Alternative Codes KIT5623
Brand Kitronik
Pack Size Each
Loading...